I think bearings are going or gone
Posted: Wed Aug 25, 2021 3:21 pm
Hi everyone, I am hearing these crunchy noises and a little jerky ness when the gantry gets up close to the front of the CNC. That is where I do most of my work about 12 to 18 inches from the front of the bed. I’ve been doing a lot of 3D stuff and It’s been doing some gouging and weird cutting. I don’t know if it’s because of that or static. I have my shark in an enclosure and had the control box on top of the enclosure. On my other HD3 I did the same thing and was getting a lot of static and screw up’s, then moved the control box to under the enclosureg and it seems to have doing a lot better. I’ve had it for 9 years and have only had to replace a card or two in the control box because of static I just did the same to this machine (moved the control box) and after doing that and cleaning it all up I noticed the noises and movement in the gantry. Has this happened to anyone else? What do I have to do to fix it? Is there any videos that can show me what to do? Thanks Tim
PS I tried to share a video of it but it said it was to big wow it’s only 39.5 MB
https://share.icloud.com/photos/0BSN9V0 ... North_Side
PS I tried to share a video of it but it said it was to big wow it’s only 39.5 MB
https://share.icloud.com/photos/0BSN9V0 ... North_Side