Wooden Cross Puzzle

Share your Shark projects with other forum members!

Moderators: al wolford, sbk, Bob, Kayvon

Forum rules
Do not post any files that violate copyright or licensing guidelines. Any post violating this rule will be deleted and the member may be banned from future use of cncsharktalk.
Post Reply
Stoelle
Posts: 2
Joined: Tue Dec 22, 2015 2:10 pm

Wooden Cross Puzzle

Post by Stoelle »

After seeing a number of wooden puzzles at a kiosk in our local mall, I thought I would try my hand in building a "simple wooden cross" puzzle. I used 3/4 inch stock to create this one, but it could be made at a number of different dimensions with modification. The puzzle consists of six pieces, each three inches long. I used a 1/8 inch end mill bit to cut out the pieces and the side cuts needed to be squared with a chisel or band saw in order for the pieces to fit snugly. After a little sanding and some wood wax, the pieces seem to fit fairly well.

You can search the internet for a solution to the puzzle using the search terms "simple wooden cross puzzle".

Using VCarvePRO 8.0 and a CNC Shark Black Diamond ....
Solved puzzle
Solved puzzle
Cut out pieces with tabs on ends
Cut out pieces with tabs on ends
Wooden Cross Puzzle.crv
VCarve 8.0 project file
(266.5 KiB) Downloaded 813 times

User avatar
Bob
Posts: 1265
Joined: Sun Aug 08, 2010 3:35 pm

Re: Wooden Cross Puzzle

Post by Bob »

Thank you Stoelle,
I will enjoy tormenting my friends. :twisted:
Bob
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)

Stoelle
Posts: 2
Joined: Tue Dec 22, 2015 2:10 pm

Re: Wooden Cross Puzzle

Post by Stoelle »

Here's a link to a site that shows a solution to the puzzle:
http://makezine.com/projects/cross-puzzle/

Post Reply