x, y, z axis and virtual setup
Moderators: al wolford, sbk, Bob, Kayvon
x, y, z axis and virtual setup
For some reason when I run virtual setup the z axis goes straight up way past what I set as the z axis point. It goes up until it hits the top level and keeps trying to go higher until i do an emergency stop. I have looked and looked at the toolpath, tried different toolpaths and even shut everything down and rebooted but still does it. Only work around I've found is not using virtual setup and just telling it to detect the touchplate. Then it's OK. HELP!, Please. Have a Nextwave Shark HD 3 with VCarce.
Re: x, y, z axis and virtual setup
Terry,
I would first check Clearance( Z1 ) and see if it's sending your Z way too high. Bob
I would first check Clearance( Z1 ) and see if it's sending your Z way too high. Bob
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)
Antonie Van Leeuwenhoek (Developer of the microscope.)
Re: x, y, z axis and virtual setup
I checked it Bob and it's set at .5, so no problem there. GRRRR.