I have a Shark SD120 and I am starting to use the tiling in vectric desktop. I am tiling two sections in the y axis. I am using just one bit for the entire project and was wondering why I get 4 tap files. Two for T1 and two for T2. Do I have to run all four tap files on the cnc or just one for T1 and one for T2?
Thanks for the help.
multi tap files
Moderators: ddw, al wolford, sbk, Bob, Kayvon
Re: multi tap files
Renee,
My first question...Have you worked with the tiling tutorial? https://www.vectric.com/support/tutoria ... ath-tiling
It's been a few years since my last tiling toolpath, but I remember only one toolpath per tile.
I'll go dig around in my old files and find out how I tiled.
Bob
My first question...Have you worked with the tiling tutorial? https://www.vectric.com/support/tutoria ... ath-tiling
It's been a few years since my last tiling toolpath, but I remember only one toolpath per tile.
I'll go dig around in my old files and find out how I tiled.
Bob
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)
Antonie Van Leeuwenhoek (Developer of the microscope.)
Re: multi tap files
Bob,
Thank for the video link. I watched it and it and you have answered my question.
Thank so much.
Renée
Thank for the video link. I watched it and it and you have answered my question.
Thank so much.
Renée
Re: multi tap files
You're welcome.
Thanks for the update.
Thanks for the update.
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)
Antonie Van Leeuwenhoek (Developer of the microscope.)