Cable management strip

Discussion about the CNC Shark Pro Plus HD

Moderators: sbk, al wolford

Post Reply
Posts: 3
Joined: Sun Aug 27, 2017 1:05 pm

Cable management strip

Post by cromag08 »

Hey does anybody know if that black plastic used to run cables on the hd4, would also work on the hd3 ext?

Posts: 583
Joined: Tue Jan 06, 2015 3:24 pm
Location: Hoquiam, WA

Re: Cable management strip

Post by Rando »

Yup, you just have to figure out a way to mount the cable track so it has something to sit on.

That stuff is pretty common in the industrial machine tool world. ... &FORM=IGRE

The only caution I would have is to make sure the track and the thing it sits on are lightweight. Any additional mass attached to the gantry can, theoretically, impact the speed or accuracy of movement along that axis (my X, maybe your Y).

It has been my experience that cable tracks work great when the cables are flexible, thin, and relatively few. In my case, the Z-axis carriage has the following cables: stepper-motor cable, spindle power, coolant in/out, under-spindle light power, static ground wire to spindle body, chip-blower air tube, fume extraction air tube, and a mister's air and water tubes. That bundle is something like 3" in diameter when you include the two air (blow and exhaust) paths. So, for me, I hang those cables from above the machine so the resulting weight on that flexy z-axis in minimized. Just another way to pelt a badger ;-)


===================================================== Creative tools and photographic art
A proud member of the Pacific Northwest CNC Club (now on Facebook)

Posts: 1
Joined: Tue Mar 17, 2020 7:01 am

Re: Cable management strip

Post by Leo85 »

for your cable management you can use these cable clips ... B00NVKHLP8 to organize them.

Posts: 3
Joined: Mon Mar 30, 2020 3:12 am

Re: Cable management strip

Post by Daniel85 »

Hi Thanks,
You can either use these cable clips ... wire-clips to hide cords behind your desk.

Post Reply