Connectors on axis cables

Questions/answers/discussion about initial setup of your CNC Shark

Moderators: sbk, al wolford

Connectors on axis cables

Postby relayerbob » Sun Jul 21, 2019 12:21 pm

Heelo! In addition to the DB9 connector at the end of each axis cable there is another small silver connector. What is that used for? Is it a limit switch?
relayerbob
 
Posts: 2
Joined: Wed Jan 23, 2019 6:57 pm

Re: Connectors on axis cables

Postby OCEdesigns » Mon Jul 22, 2019 1:50 pm

It's just a ground cable. The sharks do not have limit switches. I wish they did!!
Shark HD4 Extended Bed, Water Cooled Spindle. VCarve Pro 9.5
OCEdesigns
 
Posts: 86
Joined: Fri Jan 11, 2019 8:26 am

Re: Connectors on axis cables

Postby relayerbob » Mon Jul 22, 2019 8:24 pm

OK, thannks!
relayerbob
 
Posts: 2
Joined: Wed Jan 23, 2019 6:57 pm


Return to Setting up the Shark

Who is online

Users browsing this forum: No registered users and 0 guests