3D Cutting Depth Zero

Discussion/questions about software used with your CNC Shark and programming issues

Moderators: sbk, al wolford

3D Cutting Depth Zero

Postby DFSWoodWorks » Tue Sep 24, 2019 8:33 pm

Ok,

So, I have created a sign that has 3D carving in it. For some reason, my zero doesn't set properly and it always starts above the material by about an inch. All my other 2D vectors zero properly. What am I missing? Is this a common problem? I have the zero set to the material surface.

John
Attachments
DragonSign.jpg
DFSWoodWorks
 
Posts: 1
Joined: Sat Dec 01, 2018 9:58 pm

Re: 3D Cutting Depth Zero

Postby jeb2cav » Wed Sep 25, 2019 7:53 am

Hi John,

Check the Model Position in Material setting in the Material Setup tool. I suspect you have it set so that the model is flush with the bottom of the material, and not the top of the material.
Attachments
Model Position in Material Setting.png
jeb2cav
Site Admin
 
Posts: 1527
Joined: Thu Sep 30, 2010 7:04 pm
Location: Kentucky


Return to Software. Programming

Who is online

Users browsing this forum: No registered users and 0 guests