SHARK HD5

Questions/answers/discussion about initial setup of your CNC Shark

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
JackW
Posts: 3
Joined: Sat Oct 12, 2019 11:52 am

SHARK HD5

Post by JackW »

New HD5 and the Z axis nut broke on very first run. Can running the equipment to the maximum Z or X Y axis (basically running into the stops) cause that to fail or was that just a defective part?

Barry Anderson
Posts: 52
Joined: Sun Dec 21, 2014 9:55 pm

Re: SHARK HD5

Post by Barry Anderson »

I have an HD 3 and have hit the stops numerous times and have not had a parts failure.

Barry
Barry Anderson
Anderson Custom Woodwork, Inc.

sharkcutup
Posts: 408
Joined: Tue Mar 08, 2016 5:23 pm

Re: SHARK HD5

Post by sharkcutup »

I Have been using the HD3 Pro Extended Bed CNC Machine for three plus years now have hit stops on occasion and never broke anything on the machine!

Sharkcutup
V-Carve Pro Tips, Gadget Tips & Videos
YouTube Channel - Sharkcutup CNC
V-Carve Pro 11.554

Post Reply