New HD5 Router Carriage Off by 3/16ths

Questions/answers/discussion about initial setup of your CNC Shark

Moderators: sbk, al wolford

New HD5 Router Carriage Off by 3/16ths

Postby Sandow12 » Fri Jan 03, 2020 3:15 pm

I received my HD5 last night. During the setup I noticed the router carriage was way out of alignment. Actually all the bolts on the back of the gantry were loose. I was ale to get those tightened up and squared up the gantry mounts. The router carriage itself is way out of alignment. Front to back it is square to the table and gantry. Left to right it is off by about 3/16ths. It is even noticeable when just looking at it. Is there a way to adjust that left to right on the carriage. The rails look fine when I measure up from the deck they are even.
Sandow12
 
Posts: 7
Joined: Tue Dec 17, 2019 1:27 pm

Re: New HD5 Router Carriage Off by 3/16ths

Postby Sandow12 » Sat Jan 04, 2020 11:25 am

Support is sending me a new gantry.
Sandow12
 
Posts: 7
Joined: Tue Dec 17, 2019 1:27 pm

Re: New HD5 Router Carriage Off by 3/16ths

Postby OCEdesigns » Sun Jan 12, 2020 11:03 am

Glade Support is helping out. To bad you have to wait to get the machine up and running though. Did they say what the issue is?
Shark HD4 Extended Bed, Water Cooled Spindle. VCarve Pro 9.5
OCEdesigns
 
Posts: 96
Joined: Fri Jan 11, 2019 8:26 am


Return to Setting up the Shark

Who is online

Users browsing this forum: No registered users and 1 guest

cron