DeWalt 618 Hot Collet

Questions/answers/discussion about initial setup of your CNC Shark

Moderators: sbk, al wolford

DeWalt 618 Hot Collet

Postby Sandow12 » Sat Jan 04, 2020 11:28 am

Anyone with a DeWalt 618 does the collet get pretty hot? After routing a 10 to 15 min the collet gets very hot to the touch. This is a new router just installed last week.
Sandow12
 
Posts: 7
Joined: Tue Dec 17, 2019 1:27 pm

Re: DeWalt 618 Hot Collet

Postby Sandow12 » Fri Jan 10, 2020 11:57 am

According to DeWalt this is normal.
Sandow12
 
Posts: 7
Joined: Tue Dec 17, 2019 1:27 pm

Re: DeWalt 618 Hot Collet

Postby Bob » Fri Jan 10, 2020 11:25 pm

A cutting but can also generate a lot of heat as it gets dull. It may still appear to do a good job, and not heat enough to burn the wood. But, it can still get hot. That heat is transmitted to the collet. Improper feeds and speeds can also generate heat.
Bob
User avatar
Bob
 
Posts: 1133
Joined: Sun Aug 08, 2010 3:35 pm


Return to Setting up the Shark

Who is online

Users browsing this forum: No registered users and 0 guests