Size of Spoil Board

Discussion about the CNC Shark Pro Plus

Moderators: sbk, al wolford

Size of Spoil Board

Postby Fred Floyd » Mon Jan 06, 2020 2:46 pm

I have a Shark ProPlus with the extruded aluminum table. It is 25 x 36. Are most people using a spoil board? What should the size be for the spoil board? I have a sheet of baltic birch 3/4 plywood that could be used.

Question is that I do not want to trash the aluminum table when cutting through. The
Fred Floyd
 
Posts: 3
Joined: Mon May 12, 2014 2:52 pm

Re: Size of Spoil Board

Postby Bob » Mon Jan 06, 2020 4:04 pm

Fred,
If you do a quick search of the forum using "spoil board" you will find lots of information on the subject. https://www.cncsharktalk.com/search.php ... poil+board
I prefer to use strips of mdf covering one slot, leaving one slot open, then cover one more...repeat. Counterbore mounting holes in the mdf so bolt heads are below the surface.
Bob
User avatar
Bob
 
Posts: 1133
Joined: Sun Aug 08, 2010 3:35 pm


Return to Shark Pro Plus

Who is online

Users browsing this forum: No registered users and 1 guest

cron