X axis slop

Discussion about the CNC Shark Pro Plus HD

Moderators: al wolford, sbk

Post Reply
Posts: 46
Joined: Thu Feb 24, 2011 4:36 pm

X axis slop

Post by PeteD »

I am getting about .020 slop in the carriage on the x axis. It is not from loose connector at the motor or loose screws. How does one adjust the drive nut system to take this slop out?

User avatar
Posts: 493
Joined: Tue Oct 21, 2014 11:46 pm

Re: X axis slop

Post by Kayvon »

Could be the T-nuts are going.

Run through the tightening procedures mentioned in this thread to ensure you didn't overlook something.

If that doesn't work, the end of the thread describes procuring new T-nuts. Good luck.

Post Reply