Control Box Failure

Questions/answers/discussion about initial setup of your CNC Shark

Moderators: al wolford, sbk, Bob, Kayvon, al wolford, sbk, Bob, Kayvon

Post Reply
podpilot
Posts: 2
Joined: Sun Jun 19, 2022 7:30 pm

Control Box Failure

Post by podpilot »

Shark HD 520 purchased January, 2022. While running today, the piece moved, spindle jammed. Control box shut down completely. Has power but no lights come on.
Advice?

User avatar
Bob
Posts: 1182
Joined: Sun Aug 08, 2010 3:35 pm

Re: Control Box Failure

Post by Bob »

Where the power cord plugs into the control box there is a small cover, behind the cover is a small spare fuse. Replace the burned out fuse with this one.
Also , send for more replacements before you need them next time...
Bob
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)

podpilot
Posts: 2
Joined: Sun Jun 19, 2022 7:30 pm

Re: Control Box Failure

Post by podpilot »

Found the fuse, Thank you.

markjonesranger
Posts: 28
Joined: Mon Aug 17, 2020 3:47 pm

Re: Control Box Failure

Post by markjonesranger »

I added a relay to control the router from this low amp receptacle. I blew about 3 fuses over 2 years. I then added this router relay and no longer have to replace fuses.

https://www.youtube.com/watch?v=GEi3c1ljHjw

Post Reply