CNC Shark Forum

Hi Joe.
What is the reason for not going below 30% on FRO when in jog mode ?
Wayne.

Hi Buc.
Thanks for the link to that site. The amount of logos are endless.
You guys on this site are amazing with the wealth of information.
Keep it rolling.
Thanks again.
Wayne.

Hi Lucas,
That looks great, I would be very interested to see file.
Zac.

Jerry, You could try double sided tape. The method I use is to "sandwich" the double sided tape between layers of packing tape. Apply the packing tape to the job, then double sided tape. Apply packing tape to the table, then apply the job to the table. By using this method it is much easier to remov...

Hi Eric,
Just watched the videos.
Is the noise the router vibrating in the holder?
Have you tried tightening the router holder once it is fitted into the shark?
Wayne

Bill
Would you be able to do the drilling on a drill press, using a fence and multiple flip stops ?
Wayne

Take two Wayne

My attempt at turners cube Wayne

Hi guys, I am having the same problem as Larry, i.e. inconsistent cutting depth. I have just run a pocket toolpath program to cut 4mm deep in 1mm passes. The first run was on a 12mm thick piece of timber which cut the pocket to 4mm. I ran the same program on 73mm thick timber and the cut depth was 9...

Thanks Bob, that`s enough to get me started.
Wayne