Hey Guys!
I'm really new here but I have a question.
I purchased CNC Shark Pro Plus and I also bought aspire.
I did few thing with it and I love it. I do it as a hobby but I have a question for you: after you done machining wood do you finish it by hand in some areas or your piece comes out of CNC completely finished?
I don't know if I'm doing something wrong or it's just normal to send it by hand after you done with CNC.
Thank you very much.
Arsen
CNC shark pro plus. Please help.
Moderators: ddw, al wolford, sbk, Bob, Kayvon
Re: CNC shark pro plus. Please help.
When I do 3d work the piece is done when it comes off the machine. I use a .125 ball nose for my finish cut with a 8-10 percent step over . I usually sand my piece and put 2 coats of finish on my plaques before cutting out lettering on them.
Tony
Tony
Buffalo,NY
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.