Hi,
Can anyone help me get started with working with acrylic? Details on the base plate and LED lights, best size of material to use, should you leave the plastic on the material well cutting. And anyother tip that may help me get started. I have had my Shark for three years. I only have Vcarve pro saving for Aspire trying to make it pay for itself.
Be safe and thanks, IceStorm
first time with acrylic
Moderators: ddw, al wolford, sbk, Bob, Kayvon
Re: first time with acrylic
Hello IceStorm,
Here are the posts I found most useful (at that time). There have been several since the last of these I believe and searching using 'acrylic' will probably get you all the posts.
http://cncsharktalk.com/viewtopic.php?f=4&t=1983
http://cncsharktalk.com/viewtopic.php?f=4&t=1993
http://cncsharktalk.com/viewtopic.php?f=4&t=1984
Here are the posts I found most useful (at that time). There have been several since the last of these I believe and searching using 'acrylic' will probably get you all the posts.
http://cncsharktalk.com/viewtopic.php?f=4&t=1983
http://cncsharktalk.com/viewtopic.php?f=4&t=1993
http://cncsharktalk.com/viewtopic.php?f=4&t=1984