CNC Shark Forum

The place to talk about, learn about, and even help teach others about the CNC Shark Routing System
https://www.cncsharktalk.com:443/

Jog issue

https://www.cncsharktalk.com:443/viewtopic.php?f=2&t=3601

Page 1 of 1

Jog issue

Posted: Sun Apr 06, 2014 12:22 pm
by Jim N
I just got my new HD and Panel 2.0 up and running. When I step jog it seems to be off by a factor of 10.
Set at .1, it steps .01, at 1 it steps .1 etc.
Anyone else come across this. Am I missing something?
Thanks for any help
Jim

Re: Jog issue

Posted: Sun Apr 06, 2014 5:01 pm
by 4DThinker
It is possible the controller was programmed incorrectly. One slip of a digit would explain your error. Give NextWave support a call tomorrow if you can. This wouldn't be the first time such an error came up.
All times are UTC-05:00
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited