Shark Dust Boot
Posted: Fri May 05, 2023 7:00 am
I've been using the standard brush dust boot that came with our HD, and have now replaced it, having same issue.
I'm running dish out sections in boards with a 1-1/4" diameter box/bowl bit and the downward compression seems to be forcing the brush into the bit, have pretty much destroyed/melted two. I've never really liked this system, never seems to keep all the dust contained. Suction is from a wall mounted HEPA filter extractor necked down to a standard 2-1/2" shop vac hose to fit the boot plate hole.
Thinking I need to just stop using it for these cuts - anybody come up with something to keep the dust contained? Going about 1" deep into wood and it makes a huge amount of dust.
Thanks! Jim, Hopkinsville, KY
I'm running dish out sections in boards with a 1-1/4" diameter box/bowl bit and the downward compression seems to be forcing the brush into the bit, have pretty much destroyed/melted two. I've never really liked this system, never seems to keep all the dust contained. Suction is from a wall mounted HEPA filter extractor necked down to a standard 2-1/2" shop vac hose to fit the boot plate hole.
Thinking I need to just stop using it for these cuts - anybody come up with something to keep the dust contained? Going about 1" deep into wood and it makes a huge amount of dust.
Thanks! Jim, Hopkinsville, KY