Tool Path Stops Without Cutting
Moderators: ddw, al wolford, sbk, Bob, Kayvon
-
- Posts: 31
- Joined: Wed Dec 16, 2015 6:41 pm
- Location: St. Louis, Missouri
Tool Path Stops Without Cutting
I am attempting to run a roughing tool path using a shark CNC. I load the attached file, zero out the work space and click to run the job. The bit spins up for a second or less and the job stops without making a cut. The computer or machine do not show any type of error message. I have tried power cycling the CNC and reloading the job but get the same result. Thanks for any help on this.
- Attachments
-
- wreath rough em 25.tap
- (143.56 KiB) Downloaded 162 times
-
- Posts: 31
- Joined: Wed Dec 16, 2015 6:41 pm
- Location: St. Louis, Missouri
Re: Tool Path Stops Without Cutting
Embarrassed beyond all get out, but I "think" I figured out what I did wrong. It is the first job I setup using Aspire and I saved the file as a CNCShark-Laser (inch) (*.tap), when I should have saved it as a CNCShark-USB 3D Contour (inch) (*.tap). I just saw the (inch)(*.tap) and selected that format.
Hopefully the other file runs from a laptop.
Hopefully the other file runs from a laptop.
Re: Tool Path Stops Without Cutting
I always use the inch one
Tony
Tony
Buffalo,NY
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.