clamp down
Moderators: al wolford, sbk, Bob, Kayvon
clamp down
any ideas how to clamp down negative y axis using full deminsions
Re: clamp down
I'm not sure what you're asking.
Are you trying to clamp the material down on an axis? Or change the g-code to prevent a movement direction or boundary? Is this a VCarve/Aspire question?
Are you trying to clamp the material down on an axis? Or change the g-code to prevent a movement direction or boundary? Is this a VCarve/Aspire question?
Re: clamp down
iM TRYING TO CLAMP DOWN PART OF BOARD CLOSEST TO ME WILL USING 12 INCH WIDE X AXIS AND 13 INCH Y AXIS
Re: clamp down
In order to better understand your question, I would appreciate seeing a drawing or photo of the situation.
-Bob
-Bob
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)
Antonie Van Leeuwenhoek (Developer of the microscope.)
Re: clamp down
Yes, a picture would help substantially. With what little we know here, the only answer I can offer is, "Use a clamp," which probably isn't as helpful as you wanted.