Help with new gantry setup

Questions/answers/discussion about initial setup of your CNC Shark

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
mpsheeha1
Posts: 2
Joined: Sat Jun 10, 2023 6:35 pm

Help with new gantry setup

Post by mpsheeha1 »

I recently purchased a refurbished HD5 upgrade gantry for my HD4 from Next Wave. It is too narrow and doesn’t fit the machine… Any thoughts??? Unfortunately I can’t reach Next Wave until Monday :( The gantry brackets measure 31-1/2” across but the gantry only measures 30-7/8”… Seems like it must be an incorrect part but only one size was offered on the website like a one size fits all situation.
Attachments
IMG_9330.jpeg
IMG_9329.jpeg

mpsheeha1
Posts: 2
Joined: Sat Jun 10, 2023 6:35 pm

Re: Help with new gantry setup

Post by mpsheeha1 »

Fixed. NextWave advised I loosen 4 bolts on the back to allow the gantry to fit in place and then retighten. They thought it must have been bumped out of alignment in shipping.

Post Reply