Converting Shark to a 4' x 4' table???????
Moderators: ddw, al wolford, sbk, Bob, Kayvon
Converting Shark to a 4' x 4' table???????
OK Engineers.....Say a man bought a Shark Pro and in time wanted to extend it's size capabilities. Would it be possible for him to adjust the "span" of the motors to run on a home built 4' x 4' table? Has anyone ever attempted this?
-
- Posts: 191
- Joined: Wed Aug 04, 2010 11:28 am
Re: Converting Shark to a 4' x 4' table???????
I would say that "extending" to 4x4 would be more like "building a new 4x4 using a few parts salvaged from the old shark".
Ed
Ed
Re: Converting Shark to a 4' x 4' table???????
Yes - this man would not be so worried about the mechanics (slides, bearings, frame, etc.), but about whether or not the drives can be set to run on the 4' table.
Re: Converting Shark to a 4' x 4' table???????
Unless you get supported bearings expect a lot of deflection.