Sub programs

Discussion/questions about software used with your CNC Shark and programming issues

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
stonker
Posts: 26
Joined: Fri Oct 29, 2010 12:58 pm

Sub programs

Post by stonker »

Is the Shark controller capable of reading subprograms? I would like to program a 39mm circle pocket incrementally and position over the center then run the subprogram.

I would like to make custom mats to display poker chip collections.
The following pic is a rough layout of what I want to do.
Image

User avatar
fison
Posts: 102
Joined: Thu Aug 26, 2010 10:24 pm
Location: Tacoma, Washington, USA
Contact:

Re: Sub programs

Post by fison »

Not sure about the controller but the the Vcarve that came with your Shark has this capability built in. Look at the 'copy vectors' function.
Paul Fison
Tacoma, Washington, USA
(253) 925-0855

Post Reply