mach3 or not
Moderators: al wolford, sbk, Bob, Kayvon
-
- Posts: 7
- Joined: Sun Nov 06, 2011 11:04 am
mach3 or not
Is the shark controller a modified version of mach3? I have been told that it is. i would like to know for sure.
Re: mach3 or not
No it is not.
What are you trying to do? Which model do you have?
What are you trying to do? Which model do you have?
-
- Posts: 7
- Joined: Sun Nov 06, 2011 11:04 am
Re: mach3 or not
I would like to use the control panel on a machine other than cmc shark.
Re: mach3 or not
The NWA website says that Mach3 is compatible with the Shark Machines. I remember from the past that this may not have been the case.
I am not sure what the status of this is today, but the new NWA website says it is compatible.
I am not sure what the status of this is today, but the new NWA website says it is compatible.
Re: mach3 or not
The NWA website is in error and I've been told that they will fix this. While some early versions of the Shark hardware (white shark with 2 piece control box) was supported by a version(s) of Mach 3 at the time, there is no direct capability between the Mach 3 software and most models of the Shark - including recent versions.