Tapered Work Piece Question

Everything 4th Axis

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
Zeph
Posts: 4
Joined: Mon Dec 05, 2022 2:37 pm

Tapered Work Piece Question

Post by Zeph »

Can the standard 4th axis (or the VCarve software) be set up to handle a work piece that tapers from larger to smaller diameter?
Top
markjonesranger
Posts: 68
Joined: Mon Aug 17, 2020 3:47 pm
Location: Ozark Mo
Contact:
Contact markjonesranger

Re: Tapered Work Piece Question

Post by markjonesranger »

I don't have the hardware for this nor have I done it. But I have seen 4th axis videos on youtube that have Aspire / Vcarve videos doing this. If my memory is correct. I didn't tag them but look on youtube for them.
Top
Post Reply

Return to “Everything 4th Axis”