There have been several discussions on here about how to do second side or other secondary operations on the Shark.
The real trick is accurately locating the part.
I had to widen an opening on a Christmas gift I made this year, so I grabbed the camera and took a few screen caps to show how I do this: http://youtu.be/8Jjd4YyqIYA
Hope this helps,
Ralph
Second Side Operations
Moderators: al wolford, sbk, Bob, Kayvon
Forum rules
Do not post any files that violate copyright or licensing guidelines. Any post violating this rule will be deleted and the member may be banned from future use of cncsharktalk.
Do not post any files that violate copyright or licensing guidelines. Any post violating this rule will be deleted and the member may be banned from future use of cncsharktalk.
- Consultingwoodworker
- Posts: 333
- Joined: Fri Jul 02, 2010 7:37 am
- Location: Nashville area
- Contact:
Re: Second Side Operations
Hi Ralph,
Very nicely done. I haven't needed to do this yet but I won't forget your approach.
Thank you for your posting.
Ed
Very nicely done. I haven't needed to do this yet but I won't forget your approach.
Thank you for your posting.
Ed
Re: Second Side Operations
Very nice. I like the fact that it explains the software side but also shows it on the machine doing the work. No getting lost in translation with that type of tutorial. I'll remember this for future needs. I have needed to be able to do that in the past but wasn't sure how.
Re: Second Side Operations
Thank you Ralph,
If there is a way to to not plan far enough ahead, and need to re-do a part of a project I will find it. And when I do, I'll use this method.
Bob
If there is a way to to not plan far enough ahead, and need to re-do a part of a project I will find it. And when I do, I'll use this method.
Bob
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)
Antonie Van Leeuwenhoek (Developer of the microscope.)
Re: Second Side Operations
That's a great tip and video Ralph. Thanks for sharing your idea.
I had a situation where my son had a saw that had a plastic handle, and he wanted to replace it with an identical wooden one. After cutting out the two halves he decided it would be nice to vcarve some words on the handle so instead of making a whole new handle I used the sacrificial board from the original handle, set up the XYZ from that board and cut the lettering in the handle with great precision. Moral of the story. Hold onto pieces used when making parts. You won't know if you'll need them in the future.
I had a situation where my son had a saw that had a plastic handle, and he wanted to replace it with an identical wooden one. After cutting out the two halves he decided it would be nice to vcarve some words on the handle so instead of making a whole new handle I used the sacrificial board from the original handle, set up the XYZ from that board and cut the lettering in the handle with great precision. Moral of the story. Hold onto pieces used when making parts. You won't know if you'll need them in the future.
Rick