Can anyone recommend a place to buy 1/8" round nose bits with a 1/4" shank
Thank You
Bob
Bits
Moderators: al wolford, sbk, Bob, Kayvon
-
- Posts: 227
- Joined: Mon Aug 13, 2012 7:16 pm
Re: Bits
I believe Next wave offers them directly from their website
"I'm not smart, I just remain on problems longer"
Albert Einstein
Making many BTU by experimentation. ...some days it gets too warm
Albert Einstein
Making many BTU by experimentation. ...some days it gets too warm
Re: Bits
Amazon: http://www.amazon.com/Freud-18-100-8-In ... router+bit
If you need a longer 1/8" bit look for 1/8" tapered round nose bits. Pricey, but will last longer and reach deeper of you are doing deep 3D work.
If you need a longer 1/8" bit look for 1/8" tapered round nose bits. Pricey, but will last longer and reach deeper of you are doing deep 3D work.
- NewAgent45
- Posts: 230
- Joined: Sun Sep 08, 2013 8:29 am
- Location: Edgewater, Florida, USA
Re: Bits
I get some of my bits from Magnate.
http://www.magnate.net/Default.asp
My Magnate Ball Nose Bits are as follows:
Magnate #1965 Solid Carbide 2 Flute Up-cut 1/8" Cutting Dia. / 1/4" Shaft
Magnate #1960 Solid Carbide 2 Flute Up-cut 1/4" Cutting Dia. / 1/4" Shaft
Magnate #2502 Carbide Tipped 1/2" Cutting Dia. / 1/2" Shaft
Sometimes you may find these available from Amazon by searching on Magnate #
I have a lot of hours on both the 1/8 and 1/4 inch cutting hardwoods and Corian and my 1 1/2 old bits keep cutting good.
Have a great day?
..... Rod
http://www.magnate.net/Default.asp
My Magnate Ball Nose Bits are as follows:
Magnate #1965 Solid Carbide 2 Flute Up-cut 1/8" Cutting Dia. / 1/4" Shaft
Magnate #1960 Solid Carbide 2 Flute Up-cut 1/4" Cutting Dia. / 1/4" Shaft
Magnate #2502 Carbide Tipped 1/2" Cutting Dia. / 1/2" Shaft
Sometimes you may find these available from Amazon by searching on Magnate #
I have a lot of hours on both the 1/8 and 1/4 inch cutting hardwoods and Corian and my 1 1/2 old bits keep cutting good.
Have a great day?
..... Rod