Man I feel dumb.....I have followed the tutorial for beginners (Bulls Head) and every time I load the code and run from SD card it seems to run through the code ok but it's only moving the heads a fraction of an inch.....it's like a micro cut or something. Tried a couple of different files and same thing.
Any help or suggestions are greatly appreciated.
Thanks
New....need help extra small
Moderators: al wolford, sbk, Bob, Kayvon
-
- Posts: 7
- Joined: Wed Aug 04, 2010 11:58 am
New....need help extra small
"Whether you think you can or think you can’t, you’re right".
Re: New....need help extra small
Mike,
Are you using the right Post Processor for the Shark (CNCShark USB either Inches or Millimeters depending on what you've set everything else to)?
Is everything set to either Inches or Millimeters (both in VCarve and the CNC Shark Basic Panel)?
Are you using the right Post Processor for the Shark (CNCShark USB either Inches or Millimeters depending on what you've set everything else to)?
Is everything set to either Inches or Millimeters (both in VCarve and the CNC Shark Basic Panel)?
Paul Fison
Tacoma, Washington, USA
(253) 925-0855
Tacoma, Washington, USA
(253) 925-0855
-
- Posts: 7
- Joined: Wed Aug 04, 2010 11:58 am
Re: New....need help extra small
I was saving the file wrong........ Good to go now.
"Whether you think you can or think you can’t, you’re right".