Newbie Check list

Anything and everything CNC-Shark-related

Moderators: ddw, al wolford, sbk, Bob, Kayvon

Post Reply
acebetter
Posts: 8
Joined: Fri Jan 09, 2015 11:25 am

Newbie Check list

Post by acebetter »

I created a Check List, because as I was learning I didn't do everything on the list and created havoc more than once. 5 weeks in and I still use the list. Posting to help any in a similar situation. Items to add are appreciated.
Attachments
Check List.docx
(15.48 KiB) Downloaded 273 times

User avatar
bill z
Posts: 342
Joined: Fri Sep 25, 2015 9:09 am
Location: Spring, Texas USA

Re: Newbie Check list

Post by bill z »

You should check RPMs after each bit change.

If more than one tool path, make sure you are running tool paths in the correct order.

I forgot these in the past and had less than desirable results.

acebetter
Posts: 8
Joined: Fri Jan 09, 2015 11:25 am

Re: Newbie Check list

Post by acebetter »

Thanx!! I will add to my list.

Rando
Posts: 757
Joined: Tue Jan 06, 2015 3:24 pm
Location: Boise, ID
Contact:

Re: Newbie Check list

Post by Rando »

I'll spare you the long writeup here, and instead offer the following, one of my manufacturing sequence sheets. Like so many things I do, it's a bit overkill :o

Normally I'd make sure there's no proprietary information, but honestly, once these things get well put-together, I actually prefer NOT remembering what's on it, so I don't feel like I can take shortcuts. The excess precision helps allow that to happen, and I can be confident every detail is in the sheet.
2016-010SetupSheetv2.03+.pdf
7 Pages of Instructions, teeny-tiny font!
(776.03 KiB) Downloaded 256 times
Cheers!

Thom
=====================================================
ThomR.com Creative tools and photographic art
A proud member of the Pacific Northwest CNC Club (now on Facebook)

acebetter
Posts: 8
Joined: Fri Jan 09, 2015 11:25 am

Re: Newbie Check list

Post by acebetter »

Much thanx Thom, very thorough and extremely well organized. Greatly appreciate you sharing.

Rando
Posts: 757
Joined: Tue Jan 06, 2015 3:24 pm
Location: Boise, ID
Contact:

Re: Newbie Check list

Post by Rando »

acebetter wrote:Much thanx Thom, very thorough and extremely well organized. Greatly appreciate you sharing.
You're very welcome, Acebetter.

What I neglected to mention is that all that is for a simple aluminum angle bracket :D

Well, the holes and slots and engraving and other features are in just the right spot for a particular application, and I can pump them out by the dozens, but still...it's a $5 hunk of aluminum...that people pay me $50 for. ;-)

Thom
=====================================================
ThomR.com Creative tools and photographic art
A proud member of the Pacific Northwest CNC Club (now on Facebook)

Post Reply